AquaDopp HR 2MHz minimum cell size

Posted by Øistein Hurum at May 14. 2009

Posted by NGUYEN TAT THANG at Tuesday 20:07

Dear All

I just found that eventhough I set the minimum cell size to 7mm in the AquaDopp HR 2MHz, it still appears to be 10mm in the *.hdr result file.

Could anybody give me advice about that? Thank you so much.

Thang

Re: AquaDopp HR 2MHz minimum cell size

Posted by Øistein Hurum at May 14. 2009

Posted by Sven Nylund at Wednesday 11:36

Dear Thang,

Have you verified that you use the latest software version (which can be downloaded from our support page)?
If you have the latest software version, can you upload the header file so I can take a look?

Best regards,

Sven Nylund

Re: AquaDopp HR 2MHz minimum cell size

Posted by Øistein Hurum at May 14. 2009

Posted by NGUYEN TAT THANG at Wednesday 13:31

I am using the AquaProHR High Resolution, version 1.05 Beta5.

Could you please have a look at the attached file to see if I have had any problems with the setting?

Thank you so much.

Thang

Re: AquaDopp HR 2MHz minimum cell size

Posted by Øistein Hurum at May 14. 2009

Posted by Sven Nylund at Wednesday 14:48

Dear Thang,

Your setting is correct, this is caused by a round-off error in the software which is also present in version 1.06. Although the value is output in mm in the header file it is treated as a cm value so all cell sizes from 7-14 mm are output as 10 mm. I will pass the information on to our software programmer so that it is fixed in the next release.

Best regards,

Sven Nylund

Re: AquaDopp HR 2MHz minimum cell size

Posted by Øistein Hurum at May 14. 2009

Posted by NGUYEN TAT THANG at Wednesday 16:23

Dear Sven Nylund

Thank you so much for your explanation.

Best wishes

Thang

Sections

AquaDopp HR 2MHz minimum cell size